 |
Below is our complete list of Special Effects. For additional questions please see our Services.
|

|
 |
GOLD LEAF (Guilding)
Guilding is a craft dating back hundreds of years. Gold leaf is an extremely thin foil made of gold. It is available in various colors, each with a different proportion of
copper, silver or other metal in the alloy. Leaf made of less expensive material is referred to as composition leaf and is available in different gold varieties, silver and
copper as well. When gold leaf is applied it is referred to as guilding.
To apply gold leaf to a print, an ink drawing of the area to be guilded is made and burned into a screen. The leaf is attached to the print with an adhesive known as
gold size. It is printed on to the prints and allowed to dry until it is no longer liquid and has a tacky surface. Next the thin leaves of gold are applied by hand. This
is done with a soft brush called a guilder’s tip. Once the gold has been applied it is softly burnished and the excess gold is brushed away.
Real gold leaf will not tarnish so no varnish is necessary. The silver, imitation gold, and copper all will tarnish. They should be printed with a protective gloss coating.
Back to Top >> |
 |

|
 |
SILVER LEAF (Guilding)
Same details as for Gold Leaf.
Back to Top >> |
 |

|
 |
METALLIC OR PEARLESCENT COLORS
Metallic inks, pearlescent and interference pigments add a subtle but
dynamic richness to a print. The areas printed with these inks will be a bit more glossy but will also have a metallic sheen when viewed from certain angles in the case of the
metallic colors. The pearlescent or interference pigments will change color when viewed from different angles, much like looking at the iridescence of a butterfly’s wings.
Back to Top >> |
 |

|

|
GLITTER
It is possible to apply a layer of glitter to a print. A drawing is made
of the areas that the glitter is to be applied and the art is burned onto a special screen designed to allow the glitter to pass through the mesh and onto the print. There
are a wide variety of glitters available for silkscreen printing therefore the color range is not limited.
The same technique is used to add textural elements to a print. Colored sand available at art supply stores, dry pigments and even reflective beads can be added to
clear varnishes or colored inks, adding a unique surface to the print.
Back to Top >> |
 |

|

|
TEXTURE
The silkscreen process tends to create a print with a distinct tactile surface because each color printed is a layer of ink rather than an imprint made by pressing the
paper against an inked plate. By adding thickening agents to clear gloss coatings and printing with screens with a more open mesh this textural effect can be further
emphasized.
This is done in much the same way that a color separation is done. A drawing in black ink is made of the texture that is desired. It can be an all over effect or limited
to certain areas. It could have the look of brush strokes or could simply emphasize certain lines or design elements. Once the drawing is created it is put onto a screen
and into the printing press. It can be printed once or for a more dramatic effect, printed two or three times to build up the surface. This can also be done with UV
cure ink over a UV varnish.
Back to Top >> |
 |

|

|
HAND BRUSHED ACRYLIC
Sometimes, in order to add surface interest to a giclée print, a gloss varnish is brushed on by hand. The brush marks add a textural finish that
compliments the crispness of the digital printing. This is done on both canvas and paper editions.
Back to Top >> |

|
 |
GLOSS | EXTRA GLOSS | UV GLOSS
All of our gloss varnishes are available as well.
Back to Top >> |
 |
© 2005 Copyright MFA Atelier, Inc. All Rights Reserved. |